Thingiverse
Anet A8 Switch Holder
di BaBaBBa
2
Download
1
Likes
0
Makes
Designed this switch holder because I wanted to add and control a led strip on the top of the Anet frame.
Designed to fit in one of the big holes in the upper part of frame (25mm) and hold a ~21x15mm switch.
The file is just half to facilitate the installation, so print 2x and you're good to go.
Edit: uploaded a corrected file (was showing some errors in Cura).
Designed to fit in one of the big holes in the upper part of frame (25mm) and hold a ~21x15mm switch.
The file is just half to facilitate the installation, so print 2x and you're good to go.
Edit: uploaded a corrected file (was showing some errors in Cura).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
