Anet A8 Table Mount - Quick and Dirty ;)

Additional material needed:
8x Screws 3mm diameter (dependend on your base/bottom material)

Quick and dirty table mounts for the Anet A8 Printer. This was a 10min print with low resolution, but still yet the best optimization in noise/vibration terms!!! The printer is almost silent now, compared to the state before.

***Installation:***
1. Print Part four times (4x)
2. "Clip" mounts on the threaded shaft
3. Mark down the position of the screw holes (or directly drill the holes [e.g. 2mm hole for 3mm screws])
4. The mounts should NOT touch the bottom surface yet
5. Screw down the mounts to the base/bottom plate with two screws each

6g of filament for four pieces!