Thingiverse
Anet E10 Printer Legs
von SummersideGuy
63
Downloads
55
Likes
0
Makes
I designed a set of legs for the Anet E10 that allow you to keep the original feet in place while raising up the printer 3 inches. The leg require very little filament each. At 20% infill with 2mm wall thickness they use 54g of filament per leg. I print them without any supports one at a time with a brim.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
