Thingiverse
Anet E16 E12 Y-axis Rod Holder
par CoopaLoopa72
6
Téléchargements
2
Likes
0
Makes
These are replacement brackets for the 8mm linear rod used on the Y axis of the Anet E10, E12, and E16.
They are open ended which allows you to use longer linear rods if needed. I have 500mm rods on mine and they sit flush on the front and back of the printer frame. You can use an M3 nut and screw (18mm+) to hold the rods in place and prevent movement if your print tolerances aren't tight enough to hold them from friction alone.
I recreated these from some old STL I found that doesn't seem to exist on thingiverse any longer and added countersunk holes so you can use shorter countersunk screws if you want.
You'll need 3 of the standard Y rod holders and 1 with the end stop. Print without supports, and clean up the holes with a drill if needed.
If you print with generated supports you'll likely weld the seam together with support material.
They are open ended which allows you to use longer linear rods if needed. I have 500mm rods on mine and they sit flush on the front and back of the printer frame. You can use an M3 nut and screw (18mm+) to hold the rods in place and prevent movement if your print tolerances aren't tight enough to hold them from friction alone.
I recreated these from some old STL I found that doesn't seem to exist on thingiverse any longer and added countersunk holes so you can use shorter countersunk screws if you want.
You'll need 3 of the standard Y rod holders and 1 with the end stop. Print without supports, and clean up the holes with a drill if needed.
If you print with generated supports you'll likely weld the seam together with support material.
CoopaLoopa72 publie également sur
12 modèles supplémentaires sur 2 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
