Thingiverse
Anet tool quick release mounting system
von Conanprints
5
Downloads
2
Likes
0
Makes
a quick project that lets you keep your tools handy for when you need them, i used two 3mm diameter wood screws to hold the rail in place
NOTE: for printing the rail you are probably better to print with the most holes facing up, this means no support is needed
NOTE: for printing the rail you are probably better to print with the most holes facing up, this means no support is needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
