Slicer Discord
Angel/Demon Puzzle – 3D-Druckmodell von Thingiverse Thingiverse

Angel/Demon Puzzle

von ecoiras
46 Downloads
40 Likes
0 Makes
Zum Modell
This puzzle will display an angel or a demon depending on how you set up the pieces. As a puzzle is not much of a challenge (it's only 3 pieces!) but it's a great conversation starter to leave on your coffee/tea table. Carefully place it next to your copy of GQ magazine (or whatever people use these days to impress visiting friends) then nonchalantly pretend you didn't realize it was there until your friends ask about it. Please tell me if this trick works (I have no friends).

The puzzle is based on M.C. Escher's "Circle Limit IV" mosaic. In that design angels and demons tesselate the hyperbolic space. I reprojected the motif to planar Euclidean space and extracted the hexagonal tesselating unit. By carefuly splitting the unit tile an angel or demon can then be composed just by reordering the pieces.

To complete the model I included a tray to hold the pieces. There is a hole at the back to push the pieces out in case they fit too tight. The gap between the parts is about 0.4mm wh
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
3-teiliger Zusammenbau
Supports 1/3
Zusammenbau 1/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

ecoiras veröffentlicht auch auf

21 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen