Angle Grinder Holder for Multiboard - Won't Fall!

Gone down the deep end on Multiboard? Me too!Check out my collection of Multiboard Models here! CommentsHangs an Angle Grinder from the Protective Sheath. I designed it for my Dewalt DCG416 but likely works with others. The Radius of my Angle Grinder's protective sheath is 14cm/5.5in: I designed the “hook” to use a 13cm diameter so it fits rather nicely but not snug to the point it would be hard to put the tool back into it's place. It's working beautifully. I printed it with 4 walls and the flat side down, and with Supports. To install, add two of these BOLTS: Link And if needed, use this wrench to tighten (I used the OPEN version): Link