Angled Case for .96-inch OLED Display

This is a small "angled" case for a .96-inch OLED display. It has two mounting holes for either 3mm or #12 screws and an opening in the back for the wires. There's a wide brim on the bottom to help ensure adhesion to the printing bed.

Print the body right-side up with supports and the cover face-down.

The cover stays on with a press fit.

There are two critical dimensions - the diameter of the pins that hold the PCB and the dimensions of the cover. If your printer is not very well calibrated then the pins might be too big for the PCB holes and the cover fit might be too loose or too tight.

This is the first thing I've loaded to Thingiverse and I'm looking for some feedback. So please let me know if you have any problems printing this.