Angled DBPower EX5000 Stand

This case for the inexpensive DB5000 action camera was designed for use on a quadcopter: if you just need a stand, check out thing:1794812!

This 15g case covers most of the camera, excluding holes which allow access to every button. A lightweight base allows for easy attachment with zipties.

Please note that while designed to protect as much as the camera as possible, the lens is still exposed, as are the ports. If dust ingress might be a problem, put a piece of tape over the left side of the camera.

PRINT INSTRUCTIONS
Before printing the stand, print the test piece first, using a raft! The case is designed with very tight tolerances, so it is not safe to assume that different printers will produce the same results.
If the test piece is too tight, increase the wr (wiggle room) variable in the .scad file, set test_print to true, and print. Repeat until you have a piece which is easy to put on, yet snug.
For printing the final part, do not use supports.