Thingiverse
Angled Foregrip
door TnTCesar
119
Downloads
78
Likes
0
Makes
I designed this after the Stark SE-5 Express. The Hole is meant for M5 screw that is 35mm in lenght and a Nut that 8mm in Side-to-Side Lenth. If the grip is too tight on your picatinny rail, then I recommend heating the print a little and then sliding it back and forth to your happy with resistance it gives.
The inside of the grip is somewhat hollow, as shown in one of the screenshots. I did this to save on print fillament. When slicing the file, you can also see how hollow the inside is.
hint: if you are not experiencing warping on the flat side of your print, then I recomment printing the grip at an angle, like on the pictures, or where the picatinny is facing perpendicular to the print bed.
The inside of the grip is somewhat hollow, as shown in one of the screenshots. I did this to save on print fillament. When slicing the file, you can also see how hollow the inside is.
hint: if you are not experiencing warping on the flat side of your print, then I recomment printing the grip at an angle, like on the pictures, or where the picatinny is facing perpendicular to the print bed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
