Angled pen cup

Full attribution to madgrant https://www.printables.com/model/564661-angled-pen-cup This is an angled pencil holder which allows it to sit under a monitor. There's a slot for a sticky note pad as well. Hard to believe, but yes, this will print with no supports. There are no other special printing considerations. 2 walls are fine for structural integrity and to keep material consumption down. Infill doesn't matter, there is very little infill on this model. 0.2mm layer height with a 0.4mm nozzle works well, but 0.28mm layers would speed it up I suppose. A 0.6mm or 0.8mm nozzle with even higher layers would speed it up even more - a 0.8mm nozzle with 0.4mm layers would save 45 minutes of printing time and a few grams of filament at the expense of appearance. I printed this in Prusament orange PLA.