Thingiverse
Angled RJ45 Boot
door supersim65
0
Downloads
2
Likes
0
Makes
I enjoyed the version posted by neuttrino, but I found:
- they were too wide to fit next to each other in a switch.
- they had lovely curves, but it prints easier if ugly and square.
- a fatter cat6 or standard cat7 cable was too big for the boot.
So I made them ugly, narrower, and added a version 6.5mm hole instead of 5mm.
*While the 6.5mm accepts a cat7 cable, there is not space for the cat7 connector. Maybe if you are creative, but it's a faff.
- they were too wide to fit next to each other in a switch.
- they had lovely curves, but it prints easier if ugly and square.
- a fatter cat6 or standard cat7 cable was too big for the boot.
So I made them ugly, narrower, and added a version 6.5mm hole instead of 5mm.
*While the 6.5mm accepts a cat7 cable, there is not space for the cat7 connector. Maybe if you are creative, but it's a faff.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
