Thingiverse
Angled USB Holder
von TakingFire
70
Downloads
182
Likes
1
Makes
A small holder for extra USB flash drives, designed to match my [Angled Pencil Organizer](https://www.thingiverse.com/thing:6513225).
It sits at a 15° angle and has 11 USB slots, as well as a shallow tray at the base.
While the holder was designed around some basic Micro Center drives I had lying around, it should fit any standard flash drive just fine. Pictured at back is an oversized SD card reader for comparison.
*Optionally included is a test file to help ensure your drives fit snugly. The holder uses the center slot by default. If the 1st slot is better, decrease hole size by 0.125mm. If the 3rd slot is better, increase hole size by 0.125mm.*
No support required.
STEP and STL included in the files.
**Update 6/1/2025:**
**- Added alternate version with SD and MicroSD slots**
**- Made the front tray a bit deeper**
It sits at a 15° angle and has 11 USB slots, as well as a shallow tray at the base.
While the holder was designed around some basic Micro Center drives I had lying around, it should fit any standard flash drive just fine. Pictured at back is an oversized SD card reader for comparison.
*Optionally included is a test file to help ensure your drives fit snugly. The holder uses the center slot by default. If the 1st slot is better, decrease hole size by 0.125mm. If the 3rd slot is better, increase hole size by 0.125mm.*
No support required.
STEP and STL included in the files.
**Update 6/1/2025:**
**- Added alternate version with SD and MicroSD slots**
**- Made the front tray a bit deeper**
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
