Angles90 A90 Grips Rotating Cable Attachment

This is a handle similar to the 90-degree handle, but instead of using the flat strap, I use a 550 Paracord loop. Make sure you burn the ends with a lighter so they don't fray, then loop it through the handle and tie a tight knot to secure the loop to the handle. I created 2 versions: one is a thicker (34mm thick) more stout grip for larger hands and a thinner version (27mm thick) for standard size hands, the same size as the A90 handles knockoff shown in the picture. In each 0.4mm and 0.6mm print profile, there is also a PETG and PLA version, whichever you prefer. I also created a retainer pin for the loop so it doesn't fall out of the sides of the handles. I optimized the print profile to have at least 4 walls and 20% gyroid infill on the 0.6mm nozzle profile. For the 0.4mm nozzle profile, I increased the wall count to 6 walls and 25% gyroid infill. While I think this should be enough, you can increase it to your desired strength. I have tested these handles with over 150 lbs of pull