Slicer Discord
Angry White Tiger – Modèle 3D imprimable de MakerWorld MakerWorld
Animals

Angry White Tiger

40 Téléchargements
18 Likes
26 Makes
Voir le modèle
🐯⚡ Angry White Tiger ⚡🐯 In the misty morning of the Jade Ridge Valley, a tiny but fierce guardian sat proudly atop a stone outcrop. His fur was white as frost, his whiskers twitching in irritation. The Angry White Tiger was not angry because of danger or enemies. No. He was angry because someone dared to steal his breakfast dumpling again. 😤🐾 He stomped his little paws, sending tiny puffs of dust into the air. Birds scattered. Leaves trembled. Even the wind chose silence. The valley knew that once his tail curled in that tight spiral, something explosive was about to happen. 💢🌬️ With a low growl he sniffed the ground, following the trail of sesame scent. He marched through bamboo groves, past ancient lantern stones, and finally spotted a mischievous monkey balancing on a branch, dumpling in hand. The monkey giggled, bouncing left and right. 🙈🍙 The tiger narrowed his eyes. He crouched. Muscles tensed like coiled springs. Then he pounced. A fast flash of white and he landed perfe
Catégorie
Animals
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Débutant Confiance faible
Pourquoi ?
sans supports
Sans supports Monobloc
Supports 0/3
Assemblage 0/3
Réglages 2/3
Taille du plateau 0/3
Post-traitement 0/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection