Thingiverse
Anker 735 Side Mount
door ZacharyMaker8
1
Downloads
0
Likes
0
Makes
Summary
Fits snuggly around the Anker 735 charging block and holds it against a mounting surface (like the side of a wooden desk). It grips the Anker 735 snuggly enough that you can single handedly insert/remove your cables without it sliding out of the bracket.
Print Settings
Use 20% infill with supports only under the floating screw nub. Supports shouldn't be necessary inside the screw holes. Takes about 2hrs, 10min with normal Cura settings.
Post Process
I recommend drilling out the two mounting holes with an 11/64" drill bit and secure into place with two #6 wood screws. I used 5/8" long screws. Pre-drill into wood using 7/64". The screw holes are 54mm apart (center-to-center).
Fits snuggly around the Anker 735 charging block and holds it against a mounting surface (like the side of a wooden desk). It grips the Anker 735 snuggly enough that you can single handedly insert/remove your cables without it sliding out of the bracket.
Print Settings
Use 20% infill with supports only under the floating screw nub. Supports shouldn't be necessary inside the screw holes. Takes about 2hrs, 10min with normal Cura settings.
Post Process
I recommend drilling out the two mounting holes with an 11/64" drill bit and secure into place with two #6 wood screws. I used 5/8" long screws. Pre-drill into wood using 7/64". The screw holes are 54mm apart (center-to-center).
ZacharyMaker8 publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
