ANKER A1340 Protective Case - burly version

The original model walls is only 1mm, i.e. it's mostly “cosmetic” piece and not intended to be hauled in heavy loaded backpack over rugged terrain. It is also 2 mm short in height (i think, to be compatible with charging station). This remix is stripped of two "belts" at the back and 1.8mm thick on all the surfaces. This allow to print it with 1 outer/inner walls @ 0.4mm and use gyroid infill, which looks like tight meander and provide 2-nd wall on 50% of the each layer (see images). Printed like described above, protection case feels taut, springy and provide adequate level of protection for all the corners and (especially!) front glass panel. It also sports a nice veawy texture - because of single wall and gyroid infill.