Thingiverse
AnkerMake Spool Holder Extender
von VFDragon4
23
Downloads
12
Likes
2
Makes
Created a spool holder extender for the AnkerMake M5 to position the spool centered to the filament guide. Helps me keep the filament on the spool from binding up.
No Supports Needed. No Glue Needed.
Just put the to halves onto the spool rod, Slide the Cylinder cover over them and put in the End cap.
No Supports Needed. No Glue Needed.
Just put the to halves onto the spool rod, Slide the Cylinder cover over them and put in the End cap.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!