MakerWorld
Puzzles
Ver Modelo
Annoying Easter Egg - Single Extruder
39
Descargas
26
Likes
18
Makes
This is a fun one! I call it the “Annoying Easter Egg” because you have to remove the middle flower, which is the key, and remove 16 screws. I have all the parts on separate plates, and stripes are listed in order from top to bottom. Glue in your pieces and then have at it! Pretty simple and a lot of fun. If you aren't using my print profile, print all the parts once except:Screw: 16xFlower Dot: 3xDot: 11 NOTE: The plate with the screws and stripes does NOT need to be printed with supports. It adds a lot of print time. Also the key only fits one way! So take that into consideration.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
