Thingiverse
Another Bridge Test
por ceri
10
Descargas
2
Likes
0
Makes
After getting a new (E3D-V5) Hot end,
I had to try bridging, actually been promising myself for ages,
but one of the projects I am working on can now be printed,
knowing how far I can bridge.
There are no special settings in SLIC3R, but I think I might try to back-off on amount extruded, during 'bridging', also, my fan is a bit poor,
Will try again when fixed.
Ceri
I had to try bridging, actually been promising myself for ages,
but one of the projects I am working on can now be printed,
knowing how far I can bridge.
There are no special settings in SLIC3R, but I think I might try to back-off on amount extruded, during 'bridging', also, my fan is a bit poor,
Will try again when fixed.
Ceri
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
