Thingiverse
Another LACK IKEA enclosure
von timothyoffermans
59
Downloads
59
Likes
0
Makes
Well here we have yet another LACK - IKEA enclosure
3D printed parts:
- 4x footrest
- 12x plexiglass corner brackets
- 1x door handle
- 1x magnet strip holder
- 2x hinges (OPTIONAL)
What you need to buy:
- 2x IKEA LACK table (color of your choice)
- 4x plexiglass sheets (500mm x 500mm x 3mm thick)
- a magnet strip/sheet (needs to be cut to fit the piece)
- scews / nails (i just had a set laying around and used whatever)
i got all these parts from my local hardware store, it could be cheaper if you order some parts from China (aliexpress, banggood, gearbest etc). but i wanted to start building right away.
NOTE:
The nails are hammered into the 2 joining pieces for the footrests to lock it in place. You can also choose not to do this, this allows you to be able to remove the tables from eachother.
OPTIONAL:
I used sound canceling isolation material for the bottom of where the printer will stand on; and also have 3 more pieces laying around for in the winter
3D printed parts:
- 4x footrest
- 12x plexiglass corner brackets
- 1x door handle
- 1x magnet strip holder
- 2x hinges (OPTIONAL)
What you need to buy:
- 2x IKEA LACK table (color of your choice)
- 4x plexiglass sheets (500mm x 500mm x 3mm thick)
- a magnet strip/sheet (needs to be cut to fit the piece)
- scews / nails (i just had a set laying around and used whatever)
i got all these parts from my local hardware store, it could be cheaper if you order some parts from China (aliexpress, banggood, gearbest etc). but i wanted to start building right away.
NOTE:
The nails are hammered into the 2 joining pieces for the footrests to lock it in place. You can also choose not to do this, this allows you to be able to remove the tables from eachother.
OPTIONAL:
I used sound canceling isolation material for the bottom of where the printer will stand on; and also have 3 more pieces laying around for in the winter
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
