Another PiGRRL "0.2"

Another PiGRRL"0.2" was designed based on Pocket PiGRRL(and PiGRRL2 also).

Pocket PiGRRL
http://www.thingiverse.com/thing:807591
PIGRRL 2
http://www.thingiverse.com/thing:1277483

Requirements are almost the same as PiGRRL.
The cost should be reduced by adoption of Raspberry Pi Zero and 2.2"LCD.
On the other hand, the complicatedness of soldering and assembling will
wipe out the advantage of the cost.

-Requirement.
Raspberry Pi Zero
micro SD card (for RetroPie).
adafruit 2.2inch LCD (or compatible device)
adafruit PowerBoost 1000C
LiPo battery 2000mAh
Slide Switch
Tactile Button switch (6mm) x 10pcs
Tactile Button switch (6mm slim) x 4pcs
socket header ( needed only 10pin )
Resistor : 270 ohm x 2pcs, 150 ohm x 2pcs
Capacitor : 33nF x 2pcs, 10uF x 2pcs
Diode (BAV99 compatible or similar) : 4pcs
Some wires & soldering tools
M2.6x8mm BOLT x 9pcs
Universal board for Raspberry Pi
2x20pin Female header or IDC-BreakoutHelper-2x20_40pin

The following item