Thingiverse
Another take on a coaster
door Bluestreak66
23
Downloads
21
Likes
0
Makes
Just another take on a coaster.
I used the general size and shape of "The perfect coaster" to create this one.
The ridge is 1mm higher than the center. Grooves are 4mm deep by 2mm wide and top of the ridge is 5mm from the bottom. It can hold quite a bit of condensate before it fills up.
Overall dimensions are 80mm by 7mm.
I used the general size and shape of "The perfect coaster" to create this one.
The ridge is 1mm higher than the center. Grooves are 4mm deep by 2mm wide and top of the ridge is 5mm from the bottom. It can hold quite a bit of condensate before it fills up.
Overall dimensions are 80mm by 7mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
