Thingiverse
AnotherFilamentDryerSpacerWithWindow
door Ravgup
7
Downloads
5
Likes
0
Makes
This is a remix of
http://www.thingiverse.com/thing:3376905 by lapope47
I used his scad file to get the sizes i needed. Then i imported to tincercad for making the window. The window is for 25 x 44mm humidity and temperature sensor.
As i was having too many splitting issues on ABS, I added the ends from https://www.prusaprinters.org/prints/31900-filament-dryer-extension-for-silvercrest-dehydrato
You don't need Raft but supports are needed for the window. If you make the other plane segments then you don't need support. I suggest leave the ends on all pieces
Brim will be better for extra adhesion..
http://www.thingiverse.com/thing:3376905 by lapope47
I used his scad file to get the sizes i needed. Then i imported to tincercad for making the window. The window is for 25 x 44mm humidity and temperature sensor.
As i was having too many splitting issues on ABS, I added the ends from https://www.prusaprinters.org/prints/31900-filament-dryer-extension-for-silvercrest-dehydrato
You don't need Raft but supports are needed for the window. If you make the other plane segments then you don't need support. I suggest leave the ends on all pieces
Brim will be better for extra adhesion..
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
