Thingiverse
Ant - Liquid Feeder And Drinker
by ManManovich
1
Downloads
0
Likes
0
Makes
Why a remix?
- There are a printable bottle in remixes. The author says it compatible with the cap from mother design, but it's really not, it should be printed 103% for compatibilyty. Current caps well compatible with my and his printable bottles.
- The printable bottle is too small, so i made it bigger. now there are 10 milliliters
- The ants of my friend didn't understand how to use bottle, so i made an another variant for using cap with the sponge (cutted out the peece to put the sponge)
- Added a ring to mark on the sponge how much to cut off
The bottle consists of two parts. It is assembled without glue and holds water well. But I would use cyanoacrylate glue just in case.
K1max, 0.6mm, 0,08 height.
Supports from buildplate only for the top of a bottle.
Supports every where for cap for sponge for some filamets. (PLA printed well, but i used for abs )
- There are a printable bottle in remixes. The author says it compatible with the cap from mother design, but it's really not, it should be printed 103% for compatibilyty. Current caps well compatible with my and his printable bottles.
- The printable bottle is too small, so i made it bigger. now there are 10 milliliters
- The ants of my friend didn't understand how to use bottle, so i made an another variant for using cap with the sponge (cutted out the peece to put the sponge)
- Added a ring to mark on the sponge how much to cut off
The bottle consists of two parts. It is assembled without glue and holds water well. But I would use cyanoacrylate glue just in case.
K1max, 0.6mm, 0,08 height.
Supports from buildplate only for the top of a bottle.
Supports every where for cap for sponge for some filamets. (PLA printed well, but i used for abs )
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!