Thingiverse
Ant Moat
by wkarraker
87
Downloads
57
Likes
2
Makes
My attempt at an ant moat for a hummingbird feeder. I had some old ABS filament that I wanted to find a practical use for. This can also be printed with PLA but it is likely the water will corrupt the plastic over time.
Two sizes, 3" (76.2mm) and 4" (101.6mm).
The hook is a short piece of coat hanger wire. While the wire could be glued within the center I left ours loose so it could be straightened and replaced if necessary.
Two sizes, 3" (76.2mm) and 4" (101.6mm).
The hook is a short piece of coat hanger wire. While the wire could be glued within the center I left ours loose so it could be straightened and replaced if necessary.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
