Thingiverse
Ant Trap
by NewDesigns
1
Downloads
0
Likes
0
Makes
Most ant traps are not flush with the wall and leave a gap between the wall and the trap. This was designed to be flush with the wall and funnel ants into the trap where there is a sort of Borax Gel gauntlet. In the base there are little recessed holes for the gel (I use Terro).
Place the trap first along the ant line so they find a good route through the trap and then add the borax gel after! This way you have all the traffic going through the trap.
The open design allows for more airflow in and out making it easier for the ants to smell the gel as well. All the openings in the top are for dropping in your gel.
Happy hunting
I use a white PLA for better visibility of the ants and so I can see when I need to refill the gel.
Place the trap first along the ant line so they find a good route through the trap and then add the borax gel after! This way you have all the traffic going through the trap.
The open design allows for more airflow in and out making it easier for the ants to smell the gel as well. All the openings in the top are for dropping in your gel.
Happy hunting
I use a white PLA for better visibility of the ants and so I can see when I need to refill the gel.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
