Thingiverse
Electronics
Zum Modell
Antenna Dish Lamp
27
Downloads
40
Likes
0
Makes
Dish antenna model that holds a bright white LED. Intended to be used to illuminate a model of the moon.
Used an Adafruit Super Bright White 5mm LED, ID 754, with a 100ohm resistor. Powered off +5.0V. To avoid supports I printed the dish in two halves and glued them together, however if you want to avoid a seam it's likely printing the dish at an angle with supports is possible.
An M3x12 and M3 nut is used to hold the dish antenna into the stand.
Used an Adafruit Super Bright White 5mm LED, ID 754, with a 100ohm resistor. Powered off +5.0V. To avoid supports I printed the dish in two halves and glued them together, however if you want to avoid a seam it's likely printing the dish at an angle with supports is possible.
An M3x12 and M3 nut is used to hold the dish antenna into the stand.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
