Thingiverse
Antenna Mount
by albertk836
13
Downloads
12
Likes
0
Makes
This mount has a minimum amount of metal for the ED Fong DBJ-1 VHF/UHF antenna found on ebay. 2 are required for the antenna.
I designed it to mount on the side edge of the roof, and for any roof pitch. The mount is 3.5" in diameter so it will also fit on a standard 2X4, if the mount must be extended from the roof.
This mount was designed to fit "PVC-1120 SDR-21 PR200 PSI" 3/4" pipe which is specified in the inventors instructions.
I made mine using PLA and color matched it to the house.
I designed it to mount on the side edge of the roof, and for any roof pitch. The mount is 3.5" in diameter so it will also fit on a standard 2X4, if the mount must be extended from the roof.
This mount was designed to fit "PVC-1120 SDR-21 PR200 PSI" 3/4" pipe which is specified in the inventors instructions.
I made mine using PLA and color matched it to the house.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!