Slicer Discord
Antenna wall mount – 3D-Druckmodell von Thingiverse Thingiverse

Antenna wall mount

von Tug3
1 Downloads
0 Likes
0 Makes
Zum Modell
This is a wall mount for an antenna. The base is 97 mm wide and has a 19 mm hole to mount the antenna.

I used this for a round, flat antenna, so there is very little load on the mount. This will likely be fine for a 50 cm tall antenna, or even for a 100 cm whip.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen