Slicer Discord
Anti gravity device – 3D-Druckmodell von Thingiverse Thingiverse
Anti gravity device – Bild 1 Anti gravity device – Bild 2 Anti gravity device – Bild 3 Anti gravity device – Bild 4 Anti gravity device – Bild 5 Anti gravity device – Bild 6

Anti gravity device

von WillemvD
31 Downloads
24 Likes
0 Makes
Zum Modell
Have you ever seen a wheel rolling uphill, neglecting the laws of gravity? You can by realizing this interesting desktop gadget.
A small neodymium ring magnet (d=10mm, t=5mm) is attracted by a row of ten even smaller (5x5x5mm) cubes, hidden under a rail.
http://www.supermagnete.nl/
Make sure the orientation of the cubes is correct. The easiest way is to take the ring magnet between two fingers, and bring it in contact with one cube. The cube will position itself and can be pushed into its hole with the ring magnet. Repeat this for the other nine cubes without changing the orientation of ring magnet and rail. The climbing angle of the rail is about 20 degrees. If the ring stops halfway, the distance to the cubes is too small. There should be a layer of about 4mm between the ring and the cubes.
The ring magnet is placed at the bottom and then released. It will run uphill right to the top.
Suppose, we can shoot the ring magnet beyond the last cube and let it roll down to the s
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen