Anti-tangle bracket for Ender3 V3 Plus

This bracket is to be used with the Creality Ender3 V3 Plus, printer.
There is an issue with this printer, when homing z-axis goes up to the top
and pulls out some filament which can tangle when print starts.
I solved this problem by simply move the filament runout sensor from the z-axis
to the nearby support rod using this bracket with a ball joint so the sensor can move freely.

Remove the cable clamp on the support rod and mount the bracket there with the clamp on top of it.
You will need a longer screw for this.
Attach the runout sensor in the lower left hole to the ball joint with a screw.

screws needed:
one M3x10mm (for the bracket and clamp)
one M3x20mm for the ball joint.

There are no threads in the hole for the ball joint so you make them with the screw itself.