Thingiverse
Anti Wobble
von Kosmaa
0
Downloads
0
Likes
0
Makes
AntiWobble design for SFU1204 Linear ball screw. it has a lateral movement on XY of 1mm and a possible tilt of 1°.
should be printed with 100% infill, preferably in ABS/ASA or alternatively in PETG, it uses small 3mm shaft diameter and 10mm long with autolubricant bearing 3x5x5.
Theaded insert are M3 x 3mm long.
This model is 100% free and can be updated as you like, it is a Beta version and might need some tolerances adjustment.
should be printed with 100% infill, preferably in ABS/ASA or alternatively in PETG, it uses small 3mm shaft diameter and 10mm long with autolubricant bearing 3x5x5.
Theaded insert are M3 x 3mm long.
This model is 100% free and can be updated as you like, it is a Beta version and might need some tolerances adjustment.
Kosmaa veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
