MakerWorld
Decor
Ver Modelo
Antler
15
Descargas
10
Likes
4
Makes
I 3D scanned an antler I recently found in my backyard, and this is the result 🦌✨ It took quite a bit of work to get it printing correctly. I had to use manual supports to make sure everything came out clean and consistent. I’m sure someone with more experience in Bambu Studio could optimize the supports and improve the print profile even further, but in its current state it prints reliably and consistently 👍 Just be aware that it does require supports. This print was made using Bambu Lab Basic Blue PLA, and the final result came out looking great Boost Me
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
