Antlion Modmic Wireless Support Case

Antlion Modmic Wireless fix

Printed in PLA+ at 0.12 layer hight. can prob do 0.2, did 69% infill bec funny number but can def be less. Only non 3D printed things are glue and a thin zip tie or some string, wire, green tie (like for the garden, or something like that)

YouTube vid explaining it a bit and how to use/apply it. Any questions just message me and or leave a comment on the YouTube video.

https://youtu.be/qz_VM2Y21Ms

V15 has a support that's in the way of most charging cords getting into the charging port, so you'll need to snip it off after you glue the mic case into it. Its easy to snip off with some flush cutters like the ones that come with most printers

V16 I removed the support that was in the way of the charging port, although i haven't tested V16 so im unsure if the case will align properly without it

So the modmic wireless has a problem, the only thing holding the microphone/microphone arm to the little plastic case is hopes, dreams, and a tiny shit