Thingiverse
AnyCubic Bottle Funnel
por dafoxia
7
Descargas
3
Likes
0
Makes
# Filter funnel for Anycubic and Elegoo or similar bottels.
## Usage
This is a funnel for filling back resin from vat into the bottle. It conains a sieve to filter out bigger particles (1-2 mm or greater).
- Use resin paperfilter for propper filtering.
- Use without when no failed print happend or no contamination expected
## Printing
The funnel can be printed on a FDM Printer with a minimum bed size of 130x130 or better 140x140 mm and printing heigtht at minimum 100 mm. No supports needed, print it upside down. Layer height should be around 0.2 mm. The walls are very thin (0.4) mm for fast print. Therefore you are locked in to nozzle size 0.4mm or smaller. Unfortionally not vase mode compatible because the threading and other details.
The sieve is best printed with a resin printer. Use the suggestions of your slicer.
The sieve insert has a lose but close fit in the funnel when propper printed. You can epoxy it down or use 1-3 drops resin and cure it in with an U
## Usage
This is a funnel for filling back resin from vat into the bottle. It conains a sieve to filter out bigger particles (1-2 mm or greater).
- Use resin paperfilter for propper filtering.
- Use without when no failed print happend or no contamination expected
## Printing
The funnel can be printed on a FDM Printer with a minimum bed size of 130x130 or better 140x140 mm and printing heigtht at minimum 100 mm. No supports needed, print it upside down. Layer height should be around 0.2 mm. The walls are very thin (0.4) mm for fast print. Therefore you are locked in to nozzle size 0.4mm or smaller. Unfortionally not vase mode compatible because the threading and other details.
The sieve is best printed with a resin printer. Use the suggestions of your slicer.
The sieve insert has a lose but close fit in the funnel when propper printed. You can epoxy it down or use 1-3 drops resin and cure it in with an U
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
