Slicer Discord
Anycubic Chiron DirectDrive Conversion – 3D printable model from MakerWorld MakerWorld
3D Printer Parts

Anycubic Chiron DirectDrive Conversion

15 Downloads
1 Likes
0 Makes
Go to Model
Update 18/07/2024 Added remixed bracket for attaching the cable chain and filament sensorI now use a reverse bowden to the printhead and a feedtube from the filament to the sensorThey are both attached using PC4-M6 pneumatic fittingsFilament Sensor is now enabled againUpdated firmware to fix bugs with BLTouch. Now the BLTouch should no longer falsely trigger when probing. Probing is now considerably slower but I create my mesh and then just tilt it in my Start-GCode This is the printhead assembly of the Direct Drive conversion I did for my Anycubic Chiron. The parts I'm using:Bondtech BMG Mirrored with Bowden adapter and Nema17 Pancake StepperE3D Volcano (also fits regular V6)BLTouch V3.1BTT SKR V1.4 Turbo with TMC2208 stepper driversBTT TFT43 V3.0I used this design as a base and modified it to work with the parts I wanted to use. The model was messy to work with in Fusion360 so I also had to use negative volumes in the slicer itself to remove some leftover geometry of the old mode
Category
3D Printer Parts
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Polycarbonate
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

René Erler also publishes on

12 additional models across 1 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection