Thingiverse
Anycubic filament stop
par yodreid
2
Téléchargements
2
Likes
0
Makes
The filament spool wasn't gliding smoothly with the original holder. So I did need some side holders to fix this. The one I found didn't fit for my screws and was a bit to small for my use case. So I quickly designed this one.
It's a bit tight, so you need to push it onto the original holder. However this makes it sitting without moving around. So for me it workspretty good.
Although it is my first draft it did fit good enough for me, so it is still installed at my printer.
It's a bit tight, so you need to push it onto the original holder. However this makes it sitting without moving around. So for me it workspretty good.
Although it is my first draft it did fit good enough for me, so it is still installed at my printer.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !