Anycubic I3 Mega Bondtech + E3DV6 + BLtouch

Don't focus on Wire Management XD!!

I cannot find any good complete direct drive head for the anycubic. This head is simple. Ready for BLtouch, Tiny NEMA 17 (Pancake), Bondtech_BMG directdrive with E3DV6 hotend.

Easy acces to the PCB wires, and a support to the rear wires. If not supported, the wire break at the connector (I had to buy new wires and PCB from Anycubic).
You will need to relocate the X switch with the provided X_Switch mount.

This use the OEM metal backplate : No need to disassemble the X rod to install it, keep the linear bearings and the complete backplate.

The Part cooling duct is a slight remix from the real good AI3M Mega X cariage : I had to relocate the mount and location to fit on the OEM metal backplate, and center the nozzle with the hotend nozzle.

The rear belt carriage is the one found at in the design by MT2.

You will need a couple of M3 screws, of different lengh. I did not take time to document What goes where because i have a complete