Anycubic i3 mega c270 camera mount

I made this by taking 2 separate camera mounts and horribly smashing them together. It looks bad but it works well. I used this i3 mega go pro mount: https://www.myminifactory.com/object/3d-printer-camera-mount-mainly-for-anycubic-i3-mega-34849
And this c270 mount for the cr-10:
https://www.thingiverse.com/thing:2281259

You might need to remove the bed from the H plate to put this mount on like I did but I did this as my hands weren't wanting to co-operate in getting the screws in without taking off the bed.

The file named "bottom" is the original bottom mount from the edited bracket and left too large of a gap for me so I remade it with a smaller gap that might need to be filled with a couple wraps of tape. I think this will cut down on vibrations a tiny bit but I could be wrong.

Oh and my camera was a little loose in this mount thats why I used the tape on it. This may or may not be needed depending on your print settings.