Thingiverse
Anycubic i3 mega foldable spool holder
door pablogk95
68
Downloads
65
Likes
1
Makes
https://www.youtube.com/watch?v=rwTtr0QiVsU
All the stl are in the zip file.
Material:
2 608 bearings
1 8x88mm rod
2 3.5x10mm rods (from a nail or something similar with 3.5mm diameter)
2 M3 nuts
2 M3 countersunk screws
If you find that your spool rotates too freely and it unspools add some tape on "CARCASA_ABATIBLE" to increase the friction against the axis
This also includes the extruder since the stock one doesnt wroks. The extruder is the same as this https://www.thingiverse.com/thing:2832065 but the fix part is slightly different.
If you want to install it on the left side just mirror "SOPORTE_SUPERIOR", "FIX_PART_EXTENDED" and "LEVER 1 7mm NUT GAP" in your slicer.
All the stl are in the zip file.
Material:
2 608 bearings
1 8x88mm rod
2 3.5x10mm rods (from a nail or something similar with 3.5mm diameter)
2 M3 nuts
2 M3 countersunk screws
If you find that your spool rotates too freely and it unspools add some tape on "CARCASA_ABATIBLE" to increase the friction against the axis
This also includes the extruder since the stock one doesnt wroks. The extruder is the same as this https://www.thingiverse.com/thing:2832065 but the fix part is slightly different.
If you want to install it on the left side just mirror "SOPORTE_SUPERIOR", "FIX_PART_EXTENDED" and "LEVER 1 7mm NUT GAP" in your slicer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
