Anycubic i3 Mega LED Front Mount

2020/09/21 V2.0

The original design being snapped onto the two side screws seemed to sag down in the front, so I modified the model to be supported off the top two screws in the print head shroud. It snaps over them without unscrewing. It's a real good fit and looks really sleek too.



Here is another version of an LED light mount. This one was designed to use the following LED:

https://www.amazon.com/gp/product/B0191MU746/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

The mount snaps over the bottom two front screws of the fan mounts on each side. I wired the LED to the heat sink fan on the right so the light only comes on when the print head is heated up.