Thingiverse
Anycubic I3 Mega Light Strip
por Vellies
6
Descargas
3
Likes
0
Makes
Just a quick design of a clip-on light holder for the Anycubic I3 Mega
The slot at the back is measured at 1.34mm so would be able to fit snugly onto the top rail of the I3 mega.
Its designed to hold a stick-on LED light strip of 100mm x 8mm with a small gap on the one side for the wire to go through, will still add additional "wire clips" to this thingy that can be used to clean things up a bit.
The slot at the back is measured at 1.34mm so would be able to fit snugly onto the top rail of the I3 mega.
Its designed to hold a stick-on LED light strip of 100mm x 8mm with a small gap on the one side for the wire to go through, will still add additional "wire clips" to this thingy that can be used to clean things up a bit.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!