Anycubic i3 Mega S Bed levelling G Code

Gcode for the Anycubic i3 Mega S to assist in the levelling of the bed with the paper method.

PLEASE NOTE: Just use the .GCode file from the files on this download. The .STL file won't do anything but had to be added to this thing otherwise Thingiverse won't allow it to be published.

The code will do one complete pass over the below 5 points however for accurate levelling, you may need to run the G Code several times in a row on initial set up of your printer.

The code will move the nozzle to the following 5 points in a cross pattern.

4 2

5

1 3
The Nozzle will go to each point above, land at the base and wait 9 seconds

It will raise for 2 seconds and will again go down again to Z0 for 3 seconds

The nozzle with then continue until all points are completed.

The above is to assist in levelling the bed with paper and knobs.