AnyCubic i3 Mega Switch Box

This is a box for a Gardner Bender GSW-41 switch that will mount to the AnyCubic i3 Mega. It mounts by clipping in to the hole for the voltage switch to switch between 110/220 volts. I figured most people set that switch once, and never use it again anyhow, and there is enough room to run wires in the gap between the outer case and the power supply.I use it to switch my custom LED lighting on and off. I wanted to be able to run custom wiring in to the case so I could power the LED strip off the internal power supply, and it was in a convenient spot. I also didn't want to have to drill any holes or make any non-reversible customizations to my printer.This box originally had a bottom to it, but in the end I decided to leave it with an open bottom for several reasons. 1) it makes the supports easier to remove, 2) you can't see the bottom anyhow when it is installed, 3) less material, 4) access to switch wiring if needed, and 5) the option to run wires out the bottom if desired.I actually