Anycubic Kobra Proximity Sensor (Probe) Replacement bracket

SummaryThis was a simple part I did up during the process of repairing a Kobra that I ended up with, after updating the cooling I found that I didn't have a Proximity sensor anymore. In my case I ordered a LJ12A3-4-Z/AX from Ali and installed it. After verifying it worked with a Zip tie this was the result.2x M3 x 8mm to mount into original plate. Adjustable up and down simply using nuts to hold into correct height. Printable upright or lying down, in my case I had the block down and just cleaned up the little stringing from the overhang. No support required that way.I have done this in PLA+ but recommend PETG if PLA starts to deform although it shouldn't thanks to fan proximity. End of arm sits tight against Blower upgrade you can see.Print SettingsPrinter Brand: Anycubic Printer: i3 Mega S/Pro Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.2 Infill: 20%Filament:<a href="http://www.amazon.com/s?url=search-alias&field-keywor