Anycubic Kossel Linear Plus E3D V6 Effector

I made the connecting rod mounting points longer so I don't have to use the copper spacers anymore.
They are 52mm wide without spacers.
I added a small round brim under each mounting point to help minimize warping. Trim away post print.
I added a nut pocket so I can use a 3mm X 20mm bolt with a nut and with the rod end installed, the bolt will just reach the nut.

I have noticed with repeated assembly and disassembly that the mounting hole for the E3D will start to get a little loose, so I added 3 screw holes pointing in towards the center, to help lock down the E3D.
The top collar does a pretty good job of holding it secure, but it is better with the 3 screws. Just don't over tighten them, snug is enough.

The top collar - will take (2) 3mm x 15-20mm screws and nuts. 20's will work but 15's look a little better.

I have 2 square holes on each side. You can either pass wires through the holes, or use the holes as anchor points for wire ties, or use my little wire clips.