AnyCubic Kossel Spool Holder

This is a Remix of Foreverwinter 's Quick Change Universal Spool Holder for the AnyCubic Kossel Pully Delta 3D Printer. It attaches to the side of a 2020 extrusion, so it should work on any printer with 2020 extrusions.

I've been using it for awhile but never got around to releasing it.

It's basically just a mount and a Knob for his Spool Holder. And allows you to change the Spool without removing the Holder from the printer, or remove the holder while leaving the Mount attached.

Print as oriented and it will not require supports.

Required Non-Printed Parts:
3 x 608 bearings
2 x M8 Nuts
1 x M8 Headless Screw (appropriate length, mine is 150mm)
2 x M4x15 Hex Head Screws
2 x M4 T-Nuts

You will need to print Foreverwinter's Quick Change Universal Spool Holder, linked on the left and install the recommended 608 bearings.

The Mount requires another 608 bearing and an M8 Nut that are press fit into place and possibly glued if they are loose. The nut sits flush while