Anycubic Kossel TriGorilla Electronics Mount

These mounts were designed for the Anycubic Kossel with the 200mm build plate. They may work on other makes of this size. Additionally, for larger printers, you could easily modify the rear mounts to suite.

While overall I'm pretty pleased with this printer kit, as expected (and as many of you know), the mounting bracket that comes with this printer is lacking (also, the stupid square nuts). Mainly, the way the board mounts makes the solder joints on the bottom of the board hit the mount. That causes the board to not be level inside the printer. I also don't like electronics only being supported at one end. Also, my mount was in two pieces when it arrived (bad glue joint).

There are some nice designs for replacement here, and some do support the rear of the board, but they use long arms attached to the front. I am planning on adding some cooling to the board and didn't want to worry about any extra load on those arms. So, I went with a 3 piece design.

I used SketchUp to create