Anycubic Linear Plus Supported Board Mount

This is a board mount for the Anycubic Linear Plus Delta to replace the acrylic mount supplied with the printer.

The original acrylic mount broke on mine due to poor gluing and even after repairing it it provided very poor support to the board. I tried a few designs from thingiverse but ultimately was unhappy with them because all of the ones I tried gave very poor access to the Power wires for the heated bed. This design provides support to the board and provides excellent wire access by moving the board a little more towards the center of the printer.

After mounting the board in this Thing I was able to reuse the acrylic face plate but the USB and Power plugs are deeper than they were but they still work fine.

I made the board mounting holes undersized so you could drill them to the size and type of bolt you want to use. I used some old computer mounting screws I had laying around. because of this I would suggest at least 4 perimeters to allow for drilling.

This is a lar